(where X is either 0 or 1 in the case you have a dual switch configuration)
Youll see a key there called Median Volume which will typically default to 50 (decimal). If you bump this value up or down the overall system volume (everything, prompts, greetings, the whole shot) will go up. Its not quite linear (i.e. 100 is not twice as loud as 50) so youll have to fiddle with it. The value can be between 0 and 100 and is adjustable per provider. If you have a dual switch configuration youll have to adjust each separately until you have both at the level you want.
You may see the default here around 70 if its a T1 card youre working with since for some reason they tend to be quieter than regular analog Dialogic equipment.
I believe you need to reboot the server to reload the Dialogic drivers before the new value will take effect.
SIP is easier to make redundant. If there is more than one physical cable to the provider, then SIP can be reserved in three ways at L2, it's the Portchannel, STP and the Fex link, the same as RTG from Juniper. CUBE routers can also be reserved for ...
b+s brings Lightning to the forefront of the Salesforce Experience this summer by adding the ability to route and report on Salesforce Omni-Channel interactions.
b+s continues a product strategy of providing access to the full suite of native Sales...
11. September 2018 | Happy Landings | Frankfurt DE
Chatten Sie schon oder telefonieren Sie noch? Die digitale Kundenreise bringt den Chat-Kanal mit künstlicher Intelligenz in eine prominente Position. Nehmen Sie teil am Flug durch die Möglichkeiten des...
Collaboration Product and architecture introduction-CUCM Part(7/30)
A system has a 2 way divisible room with two SX80s. When the rooms are combined, only one codec will be used. User does not want a notification message displayed on the secondary Touch10.
Is there a method to lockout control of a Touch10 to pre...