Dears
Please I have applied TCL config to enable AA on the voice gateway , after i replaced my created audio with the existing welcome.au file , but still the demo welcome is active when i make call , below is the configuration , could you help why my created audio not become active ?
service aa flash:/its/its-CISCO.2.0.3.0.tcl
param operator XXXXX
paramspace english language en
paramspace english index 1
paramspace english location flash:/its/
param max-extension-length 5
param aa-pilot BBBBB
param welcome-prompt en_welcome.au *** this audio is my created audio
!
thanks for your help .