01-18-2006 03:46 PM - edited 03-13-2019 11:51 AM
I have a 2801 as a cme and when I make a conference between two pstn parties and a local user, the conference is fine, but when one of the participants is a remote phone in my wan site, the conference can not be completed. I assume this a codec issue because I have g729 with my wan router and g711 to the pstn. I read something about using a network module as a transcoding resource, but I want to know if it's possible and how I use the local unused DSPs of my router.
01-18-2006 04:33 PM
Jose,
it is possible to use the dsps on your 2801 (if you have enough left) for transoding:
Dragi
01-19-2006 09:38 AM
I checked this link but it focused on the external NM and I want to know how I do it with the on-board PVDMs
Jose
01-20-2006 01:48 PM
It's the same thing. If you read the prereqs on that page, you will see that the document applies to both.
Dragi
P.S.
Again, be sure that you have enough dsp resources to configure anything.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide