03-27-2006 08:36 AM - edited 03-13-2019 12:39 PM
Hey,
i configured toll bypass between to PBX sites using dial-peers and preferences. now it works fine but, if my WAN link goes down the call will fail and not go back through its local PBX. when the link is up and my lines are busy on the remote end it works fine and will reroute through the local system.
any sugesstions will be greatly appreciated :)
thanks
03-27-2006 08:53 AM
You would need the Advanced Voice Busyout(AVBO) feature to monitor you WAN interface and the remote end interface and reroute traffic if either the WAN is down of when the remote end is not reachable.
Please check this link for more details on AVBO.
http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a00800801f3.html
Regards,
Anup
03-27-2006 09:07 AM
nicely,
learning everyday...:)
thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide