11-02-2004 02:38 AM - edited 03-13-2019 06:52 AM
Hi All
I own a Cisco 827-4v connected to Telecom Italia dsl network
It works this way:
interface Ethernet0
ip address a.b.c.d 255.255.255.248
interface ATM0
no ip address
no atm ilmi-keepalive
dsl operating-mode auto
interface ATM0.1 point-to-point
ip address w.x.y.z 255.255.255.252
pvc 8/35
encapsulation aal5snap
ip route 0.0.0.0 0.0.0.0 ATM0.1
ethernet addresses (6 useful)are assigned by isp
no work is permitted on atm0.1 as provider block with access-lists all traffic on this ip
all traffic generated by lan a.b.c.d is routed regularly through cisco
Problem :
Voip traffic generated by the 4 inner voice ports, is routed out as generated by atm0.1 (w.x.y.z) so provider cut it dramatically.
Is there a way to configure cisco to present voip traffic as generated by ethernet(0) ?????
Thank you for interesting in my problem.
Bye
11-02-2004 04:57 AM
Hi!
Try this:
h323-gateway voip bind srcaddr a.b.c.d
Regards,
Nikola
11-02-2004 04:57 AM
Under your Ethernet interface if you add the following line:
h323-gateway voip bind srcaddr a.b.c.d
That should force the gateway to use this interfaces IP address as its source IP address.
Try that
Andy
11-02-2004 08:47 AM
IT WORKS !!!!!!
Thank you both for information !!!!
Best regards.
Federico.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide