Here is the statement from AVVID QOS SRND p118. Does this mean if I have two policy on the gw, and priority queue in the two policy has to use same method, either absolute or percentage? Thanks
If the percent keyword is used for one LLQ provisioning, then it must be used for all other LLQ
provisioning (as in the case of voice and video). Likewise, if an LLQ is provisioned in terms of absolute
kbps, then any additional LLQs must also be provisioned in absolute kbps.
Inside a single policy map, you must use either percentage based or explicitly stated bandwidth with the priority command. You cannot use both within the same policy map.
Hope this helps. If so, please rate the post.
Exactly as Brandon said, each class within a service-policy need to have consitent bandwidth units, for example assume the following example:
class-map match-any VOICE
match ip dscp ef
class-map match-any CALL-SETUP
match ip dscp af31
match ip dscp cs3 !
priority percent 33
bandwidth percent 4
you could not do the following:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: