05-24-2002 07:23 AM - edited 03-12-2019 06:58 PM
I would like to send calls over my point to point T1 between two locations.
Can anybody tell me what Network Modules I need for the physical connection to the PBX's? I will use a 2600/3600 platform for my routers and a T1/PRI interface at the PBX.
05-28-2002 02:37 AM
we use an nm-hdv-1e1-30 to connect to our pbx, if you are using t1's then i think you just change the part number to nm-hdv-1t1-24 (but you'll need to confirm that)
hope this helps
05-28-2002 08:03 PM
I guess u did not tell it clearly. u are using the T1 connection to communicate with 2 end if so then u need another T1 or E1 card to terminate the voice date or tie up this to ur PBX system in this case u must ask to ur PBX expert that does the PBX system support the T1 or E1 ... or else if u need 4 circuite then u can go for E&M Card but in that case u need also the same E&M module for ur PBX system. any way .. best of luck
Regards
Minhaz
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide