Other Data Center Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Save 25% on Day-2 Operations Add-On License

 

Forum Posts

HI,   Pls confirm the reason for Sw reload as no one user mgmt. port   Kernel uptime is 0 day(s), 0 hour(s), 25 minute(s), 29 second(s)   Last reset at 326324 usecs after  Fri Dec 15 14:47:08 2017     Reason: Reset triggered due to HA policy of Reset...

HiI want to apply QoS scheduling using 8 classes per interface in the nexus 5672 As far as I know , Nexus 5600 have 8 queues per portSo in the ingress port, I want to apply  COS mark using 8 class-maps and policy-map type qosbut I don't understand wh...

yk21com by Level 1
  • 735 Views
  • 1 replies
  • 0 Helpful votes

HI Team,Kindly assist for pre-provisioning the N2K(N2K-C2248TP-E-1GE) FEX with Nexus 9372.Tried using the below commands just similar to/with Nexus 5K, but no luck with Nexus 9372In case of 9K,Nexus 9372# sh fex  FEX         FEX           FEX        ...

Comm Team by Level 1
  • 2002 Views
  • 2 replies
  • 0 Helpful votes

We have 2 nexus switches in vPC for DC Aggregation. A reload to primary vPC causes a 2 minutes 17 seconds outage in the Data center. The reload was a very unusual occurrence since the DC is power redundant. However, we are proactively finding a solut...

Dear all, I would like to ask you guys about checking port. I had a switch and it connected to patch panel. when I used command "show mac add-table" to show mac-add table then it showed many mac-adds connect to 1 port. For example: <number vlan> <MAC...

Harry Vo by Level 1
  • 704 Views
  • 1 replies
  • 0 Helpful votes

Dears,   I m trying to set a ntp and I am not able to setup nor a timezone, nor a clock, here are the below outputs from the timezone and clock commands they are seen in the commands but when I apply them they give me invalid output.   Also how I can...

adamgibs7 by Level 6
  • 1429 Views
  • 7 replies
  • 0 Helpful votes