Other Data Center Subjects

Hi, The protected port concept is still valid when it comes to a data center or is any other better solution  Thanks

Dear all,I’m currently studying the cisco forecast reports, trying to figure out the percentage imagesand picture account for in overall internet data traffic. Most of the reports explicitly mentionvideo in their graphs, but images are absent.Are the...

I am locking down a LAN to STIG compliance.  One of the requirements is to limit the time allowed to negotiate an SSH connection to 60 seconds or less.  In IOS this is accomplished with the "ip ssh time-out 60" command.  This command does not exist i...

if you wanted to have the end-nodes use stateful DHCPv6, then the RA would contain the bits A=0 his nexus running  version 6.2(16) has the following config: nterface Vlan175 ip flow monitor UW-IPv4-DEFAULT input ipv6 flow monitor UW-IPv6-DEFAULT...

Does IPDT run on a nexus 7k with 6.2.16. I was asked to DISABLE IPDT but as far as I know it does not run on NX-OS 6.2.16 only on older version 4.x.

Just wondering why we are limited to only using 100-199 for FEX numbering...?Just came up with a port-channel numbering scheme for two rooms and ended up using numbers above 200 to designate rooms (ie 212 - room 2, rack 1, FEX 2). Having to rethink i...

Hi all, The Cisco Nexus 2300 platforms can do local switching between one and other FEX without the traffic be sent upstream to the Nexus 7000 parent switch? Can you help me, please? Thank you! Allyson

Going through our 5k configs I see LACP configured with VPC commend and without VPC commend as below: interface port-channel105  switchport access vlan 80 switchport mode access  vpc 105 and  interface port-channel105  switchport access vlan 80 swi...

Hi Experts, We faced issue where supervisor switchover cause the complete chassis reload. Can anyone guide/help me in identifing the root cause for this, as everytime duing switchover there is an outage due to complete chassis reload. Issue BRIEFING ...

Hi support, i want to verify if the Nexus 93180YC-EX can be a parent for the FEX 2232PP and FEX 2348UPQ. can you let me know

Good morning everybody. My question is about the port fencing agent. I suppose there is a special license to integrate it in the current configuration. I would like to know how to integrate it in my environment which is composed by CISCO MDS 9710. T...