Other Data Center Subjects

Hi, guys! I`m going to implement EVPN services on ASR 9k. And it`s very important to realize the scalability of this platform now. For example, the number of EVI,  the number of EVPN-VPWS SH, and the number of EVPN-VPWS MH. Where is it possible to fi...

Hi,When we take snapshots for the VM  in a Datastore created by HX it's reporting below"VM's disks are not on HyperFlex Datastore".   We have Vmware Hypervisor on HX platform. Taking snapshot via plugin and directly via HX gui fails.We use Veeam as b...

Hi guysI'm trying to upgrade the HX cluster but stucking in post-upgrade tasksI'm trying to upgrade the HX cluster as follows:1- HXDP from 3.5(2d) to 3.5(2i) as a first step and then to 4.5 as a final step2- ESXI 6.0 u3 to 6.5 U3  as a first step and...

Hello Community,I have recently deployed a HyperFlex cluster (version 4.5.0(2a)) and I am trying to install Cisco HyperFlex HTML5 plugin for VMware vCenter (HyperFlex-VC-HTML-Plugin-2.1.0.zip). I followed the process mentioned under KB: https://www.c...

Welcome to the Cisco Support Community Ask the Expert conversation.  This is an opportunity to learn and ask questions about Overlay Transport Virtualization (OTV)Overlay Transport Virtualization (OTV) on the N7K is an industry-first technology that ...

Hello everybody,i do have a quesiton regaridng design. in our company (medium size) it was up to now typical to have a dedicated storage network based on Fibrechannel. interrupt was done by FCoE but this was not a lasting solution. but it seems that ...

Hello,  I'm trying to start VNC console using REST API on NFVIS.According to NFVIS API reference you have to do POST request to  /api/operations/vncconsole/start without payload, which obviously doesn't make sense as host might have multiple VNF depl...

Trying to understand the tagging actions of : service-template v107match outer-vlan 107rewrite ingress pop outgoing-tpid dot1.q

I walked into a job with tripping breakers. I need to know the draw on DNAc, FMC/FTD, UCS.  They have 770W dual power supplies.We have two separate 30amp circuits that trip the breaker and it appears two rack PDU with 24 plugs where 22 are connected....

Team , i have one HX cluster and tried to expand capacity by adding new disk , but after i add new disk its shows in "Disk not in use" status and i did acknowledgment but disk still not claimed or status changing .   2.12.0.0 2.12.0.0 2.12.0.0

Hello, I would like to check if the following chassis is fully supported with newer FIs such as 6454. The concern is about Hardware Revision 0. As per 6400 series FI spec, Cisco UCS 5108 rev 1 and rev 2 chassis are both supported with FI 6454 and 641...

Hi all,I have one of redundant supervisor module in Nexus 7010 that cannot boot up. I tried to do recovery from loader but it cannot boot the kickstart image and reboot again. The log is :loader> set ip 192.168.253.10 255.255.255.0                   ...

I have 2 Nexus 9K in a VPC domain at the Access layer.  I want to add 2 more 9Ks to the Access layer.  What is the best practice?  I can't add the new 9Ks to the Core due to available ports so I can only connect them to the existing 9Ks in the Access...