Other Data Center Subjects

How do we decide about the bandwidth required for a new link. One site has 100 users (Data), no Voice, no Video Another site has 100 users (Data, Voice, Video) My knowledge and understanding for Voice & Video users) 60-65% concurrent users.Voice - 16...

Hi There, Can anyone tell me how to make default port in Cisco Data Center 5K Switch?  When I do show run int e2/10 [the output shows as follows]   switch(config-if)#  medium p2p This interface has been changed into L3, I have tried to bring it back ...

Its a great question.

Hi,     I want to know if there is any Cisco switch available with support for both NETCONF and YANG? I know Nexus supports NETCONF but I am concerned about YANG support as well. Thanks

Hi, This is Mohammed Shareef On one of my client's site i am receiving " rx lower power threshold error on Cicso 4500 " on the ports 5/2 and 6/2, there is no uplinks on these ports. May i know why i am receiving this error and what is the solution...

What is so special about OTV? Why cant we just simply extend vlans across DCs using an L2 link between them using a service provider?

Hi!, We have a rare behavior on a couple of Nexus 7010. We have connected a new server with two interfaces configured as active/standby to a couple of nexus FEX interfaces. Something like this.-----------Server||-----> NIC1 (active) ---> Interface 10...

why FEX (2K) dual-home connections to N5K is not recommended design?

I need to migrate vlans from a pair of 6509s to a pair of Nexus 7004.  I connected the 7004 to each other with peer-link and each 7004 has a single trunk to each 6509.  The vlans show as trunking across the links but 2 things occur when I go to migra...

Hi all,I have the following setup:2 Nexus 9372PX (NX-OS Release 7.0(3)I1(1a) ) in a VPC-Configuration4 Nexus 2248TP-E, 2 are attached to Nexus_1, 2 are attached to Nexus_2Attached to one of the FEXs is a Microsoft NLB (mac_addr 03bf.0a04.023c, ip_add...

In a Vxlan Spine-and-leaf topology, what's the best practice to place the Internal and External routing function:  in the Spines and border leaves?

Hello, I have some questions about ASR9K's Power-supply when I Issue command 'admin show environment power-supply' It shows a list below :  RP/0/RSP0/CPU0:bb01.sam.gr#admin sh envi poThu May 12 08:26:29.806 KSTR/S/I Modules Capacity Status (W)0/PM0/...

Is it possible to transfer Sup Modules and Line Cards from Nexus 7010 Chassis to 7004 chassis.  We have (2) 7010 chassis with four occupied slots, and one of the chassis will be going to the DR site.  We don't want to occupy free rack space with empt...