Other Data Center Subjects

I was asked a question and when i started over thinking the answer, i got myself unsure  so i hope someone can help. I have a GigabitEthernet with a fiber SFP (GLC-SX-MMD-CT) and had a question about BW.  is the interface capable of 1gb up and 1gb d...

Hello everyone, I was using cisco 3945 router for WAN Connectivity and WAAS below is the BoQ C3945-VSEC-SRE/K9Cisco 3945 SRE Bundle, SRE 700, PVDM3-64, UC, SEC Lic. PAKCON-SU1-3945VSSRIPS SVC, AR NBD Cisco 3945 SRE BundlePWR-3900-ACCisco 3925/3945 AC...

Hi, I would like to know whether Cisco ACE 4710 will support NAT64 or not. If yes, could you please share the configuration  Software Version: *********************system:    Version A4(2.3) Regards, Siva Shankar S

Good morning all, I am getting started using a Nexus Data Broker (and Cisco in general), so please take it easy on me. I cannot figure out how to get the NDB to pass traffic. I believe that I have the Configured Ports, Monitoring Devices, Configur...

Hi Guys, On our 6500s we often use the "ip helper-address" command for PXE boot scenarios.  However when trying to configure the same command on the Nexus7K platform we've observed that the command isn't available, but rather : ip dhcp relay address,...

Hi, How mac scaling and flooding behaviour of switch will be improved if spine and leaf architecture implemented . Thank you

Hi every body, I need your help i want to install DCNM for monitoring two Switches Cisco Nexus 5596 to first time  The questions are: What need for this tools What need to configured in the nexus What need to configured in a DCNM Server What need t...

Dear All, I have one doubt for cisco N5k fcoe. I am modifying all my default ethernet mtu to jumbo mtu 9216 using the below command. policy-map type network-qos N5K-JUMBOclass type network-qos class-fcoepause no-dropmtu 2158class type network-qos...

Hi, I am looking for a detail configuration level active active Data center document. I have got a design doc (Data Center InterconnectDesign Guide for Virtualized Workload Mobility with Cisco, EMC and VMware). Can anyone   provide the configuration...

  FW1     FW2  |             |         N7k1 = N7K2   || //      \\ ||   N5K1 = N5K2    \ \     / /          FEX            |        Laptop     Intermittent ARP failures to FW1 Firewalls run in Active/Standby - unable to form a port channel to the N7...