cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1269
Views
0
Helpful
1
Replies

can we use SVI as peer link on 5K?

sidranetwork
Beginner
Beginner

can we use SVI as peer link on cisco Nexus5548 Chassis?

? or only management interface will work?

If we can use SVI can we use the switch-profile?

If yes we are having the problem with switch-profile syncronization and we are using the SVI as peer link.

switch-profile  : 5kpeer

----------------------------------------------------------

Start-time: 253279 usecs after Thu Aug 29 07:54:08 2013

End-time: 447786 usecs after Thu Aug 29 07:54:10 2013

Profile-Revision: 15

Session-type: Commit

Session-subtype: -

Peer-triggered: No

Profile-status: Sync Success

Local information:

----------------

Status: Commit Success

Error(s):


Peer information:

----------------

IP-address: 1.1.1.10

Sync-status: Not yet merged

Merge Flags: pending_merge:1 rcv_merge:0 pending_validate:0

Status: Peer not reachable

Error(s):

Same is the output for another switch

sh run vpc

!Command: show running-config vpc

!Time: Thu Aug 29 08:13:03 2013

version 5.0(3)N2(1)

feature vpc

vpc domain 4

  role priority 100

  peer-keepalive destination 1.1.1.10 source 1.1.1.9 vrf KEEPALIVE

  peer-gateway

interface port-channel10

  vpc peer-link

interface port-channel31

  vpc 31

interface port-channel101

  vpc 101

interface port-channel102

  vpc 102

Please suggest the next step

Thanks

Pawan


1 Reply 1

Hafiz Butt
Beginner
Beginner

Please follow thee steps to configure vPC on Cisco 5000 Series Switch 1 shown in Figure 4.

http://www.cisco.com/en/US/prod/collateral/switches/ps9441/ps9670/configuration_guide_c07-543563.html

Hope this may helful to you

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers