cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
155
Views
0
Helpful
0
Replies
Highlighted
Beginner

Cisco UCS: Port-channel between FI 6120 and Nexus5548UP

I faced with strange situation. Now I use schema with Direct-connected NetApp Storage.

It means, 2 FI has direct connection to 2 FAS3240 NetApp Storage. I configured service profiles to boot from NetApp via iSCSI. Boot VLAN in service profiles marked as Native. Also I created Boot vlan on Uplinks, how it required.

It works well, but I'm going to set 2 Nexus5548 between FI's and NetApp.

I read documentation and create vPC on Nexus's with LACP active mode. But when I create Port-channel Appliance on FI, it didn't get up and I got errors: No operational members. I started troubleshooting and found out that if I exclude Boot VLAN from port-channel, it works, and I can add another VLANs to this port-channel. But if I add this Boot VLAN to port-channel, Port-channel can't start up.

0 REPLIES 0
Content for Community-Ad
This widget could not be displayed.