cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
464
Views
20
Helpful
2
Replies

Cisco WS-4516

rehansak11
Beginner
Beginner

Hello everyone,

Hopefully someone can help me, I have a 4506 catalyst switch with WS-X4516 Supervisor Engine V link below,

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-4500-series-switches/product_data_sheet09186a00801fcaba.html

when I boot up the switch it is at "rommon1" prompt, what firmware should I download, I am new student learning, your help will be greatly appreciated.

Thank you 

James

1 Accepted Solution

Accepted Solutions

vivek srivastava
Rising star
Rising star

give "boot" command in "rommon 1" prompt.

if still not working then need to see the config-register value.

View solution in original post

2 Replies 2

vivek srivastava
Rising star
Rising star

give "boot" command in "rommon 1" prompt.

if still not working then need to see the config-register value.

Posts in this discussion have been removed due to possible misconduct. Please refer to the CSC terms of use for more details. https://supportforums.cisco.com/document/29951/cisco-support-community-acceptable-use-agreement

 

The Cisco Support Community

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers