cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1174
Views
0
Helpful
2
Replies

Diffrent Voltage and Hot swap power supplies.

jared1995
Beginner
Beginner

I have not been able to find any information regarding this post. I am guessing it is pobrably because it can not be done. We are upgrading to a 208 V instead of 120 V. Is this an option when swapping power supplies(PS)? In short, is it possible to have 1 out of three PS be of a different V and Amp?

2 Replies 2

jared1995
Beginner
Beginner

Forgot to mention, this is a Cat 6500 series and there is two PS instead of three. Any help?

We tried it on a test chasis. It does work. I wouln't expect anything less from Cisco. To upgrade to a higher power supply hot swap works the same. Actually the switch can operate with power supplies of different wattage.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers