just getting into Fabric Path as we are replacing our Nexus 5500s with 56128 in our DC.
Been reading a bit and I'm still not sure if we can enable FP and IP on our VLAN interfaces that I want to run FP on?
Currently we have 4, 5500s. 2, are Cores with L3 routing and 2, are Distribution L2 only. We were thinking we might collapse the 4, Nexus switches into 2. If we were to do that would it make FP impossible...as we would need to run L3 for inter VLAN routing on the same switch?
Howdy out there in automation land!!!! So.... To Atomic or Not To Atomic.. that is the question? Is it not? This post is going to break into the string of "back to the basics" as we have gotten a lot of interest in Action Orchestrator of late (which is st...
Cisco Intersight Universal API Calls
The Cisco Intersight Universal API Calls module provides a set of functions that simplify creation, retrieval, modification, and deletion of resources on Cisco Intersight. Any available API types listed in the Cisco I...
Day 2: ✅. Day 3, ready to roll! Want to fine-tune your agenda for today? These sessions still have space:
Data Center Networking
BRKACI-2403: Meeting Business Compliance and IT Governance Using Cisco Network Assurance Engine (NAE)
Day 1 is done! If you're thinking about dinner plans, we hear San Diego has great food. While you're waiting for your first shot of tequlia table, keep building your Cisco Live agenda! There are more great sessions still open for tomorrow,&n...