Hi,
I have tried to send telemetry only if the status match to filter-condition, but the switch sent telemetry in both modes.
I also tried to send telemetry only if there was a change, but the switch sent telemetry in both modes.
The switch's configuration are shown below:
sensor-group 100
data-source DME
path sys/bgp/inst/dom-default depth 0 filter-condition eq(data.bgpDom.attributes.holdIntvl,"200")
path sys/bd/bd-[vlan-10] depth 0 filter-condition and(updated(l2BD.operSt),eq(l2BD.operSt,"down"))
I relied on information from this page:
Thanks
Yop.