Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
693
Views
0
Helpful
1
Replies

Mounting Nexus 7K

PATRICK HARRIS
Level 4
Level 4

‎01-02-2013 07:34 AM - edited ‎03-01-2019 07:13 AM

Recently purchased 2 Nexus 7009 Chassis for our datacenter. We are wanting to mount side by side in two post racks. Is this a supported mounting config since the 7009 uses side to side airflow. The clearance between the chassis is approximately 7 inches.                   

Labels:
0 Helpful
1 Reply 1

chrconlo
Cisco Employee
Cisco Employee

‎01-02-2013 09:58 AM

From the site prep guide:

Required clearances between the Cisco Nexus 7009 chassis and the edge of its rack or interior of its cabinet are as follows:

11  inches (27.9 cm) between the side of the chassis and the interior of  the cabinet or the clearance area for the next rack or cabinet (required  for side-to-side airflow with all types of racks or cabinets).

http://www.cisco.com/en/US/docs/switches/datacenter/hw/nexus7000/site_prep/guide/siteprep_rack.html

0 Helpful
Customers Also Viewed These Support Documents