Hi,
I have a Network Analysed Module in a
switch, and strangly it is not capturing anymore. It´s meet the system
requierment and it was working just fine 2 weeks ago, i have tried to
clean up old capture, same issue. Error message i got is: "please check
the NAM snmp to the switch", when i´m in the GUI in setup --> Switch
parameters.
Does
someone knows anything about this ?
Regards
Hi,
Try to check the parameter Wrap when Full and try capture and is snmp configuration is configured reagrding the switch community string in NAM.
http://www.cisco.com/en/US/products/sw/cscowork/ps2803/products_tech_note09186a00800948b5.shtml#topic1
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
