08-22-2013 02:19 PM - edited 03-01-2019 07:24 AM
We are setting up OTV on the N7K in unicast mode. Do I still need IGMP v3 configured on the join interface ? And then on the Other side of the Join interface does that interface need IGMP v3 enabled as well?
example
Production VDC:
interface port-channel8
description to OTV-VDC-Join Interface
mtu 1600
ip address 172.23.1.213/30
ip ospf network point-to-point
ip router ospf 2 area 0.0.0.0
ip igmp version 3
OTV VDC:
interface port-channel8
description to Production-VDC _Join Interface
mtu 1600
ip address 172.23.1.214/30
ip router ospf 2 area 0.0.0.0
ip igmp version 3
interface Overlay0
otv join-interface port-channel8
otv extend-vlan 201
otv adjacency-server unicast-only
no shutdown
08-23-2013 01:57 AM
Have a look at this guide that provides a configuration example for Unicast mode
http://www.cisco.com/en/US/docs/solutions/Enterprise/Data_Center/DCI/whitepaper/DCI_A.html
See below a snippet from the guide
interface Ethernet2/5
description [ To the OTV Join-Interface ]
ip address 172.26.255.97/30
ip ospf network point-to-point
ip router ospf 2 area 0.0.0.0
ip pim sparse-mode
ip igmp version 3
no shutdown
Don't forget to rate all helpful posts
08-23-2013 10:00 AM
You still need a command "ip igmp ver 3", the only difference in the configuration point of view is in the Overlay Interface.
07-31-2014 02:58 PM
has anyone successfully got this to work?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: