cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
149
Views
0
Helpful
0
Replies
Highlighted
Enthusiast

N7K policy-map output not displayed

Hello all,

When attempting to view a policy on a nexus 7k interface I cannot see the offered rates as you would normally see. Any ideas?

Here is how mine shows up:

7k01# sh policy-map interface e1/1
Global statistics status :   enabled

Ethernet1/1

  Service-policy (queuing) input:   default-in-policy
    SNMP Policy Index:  301989921

    Class-map (queuing):   in-q1 (match-any)
      queue-limit percent 50
      bandwidth percent 80
      queue dropped pkts : 0

    Class-map (queuing):   in-q-default (match-any)
      queue-limit percent 50
      bandwidth percent 20
      queue dropped pkts : 0

  Service-policy (queuing) output:   Nexus-QoS-10G
    SNMP Policy Index:  301992049

    Class-map (queuing):   1p7q4t-out-pq1 (match-any)
      priority level 1
      queue-limit percent 20
      queue dropped pkts : 0

    Class-map (queuing):   1p7q4t-out-q2 (match-any)
      random-detect cos-based
      random-detect cos 7 minimum-threshold percent 80 maximum-threshold percent 100
      queue-limit percent 5
      bandwidth remaining percent 5
      queue dropped pkts : 0

    Class-map (queuing):   1p7q4t-out-q3 (match-any)
      random-detect cos-based
      random-detect cos 6 minimum-threshold percent 80 maximum-threshold percent 100
      queue-limit percent 5
      bandwidth remaining percent 5
      queue dropped pkts : 0

    Class-map (queuing):   1p7q4t-out-q4 (match-any)
      random-detect cos-based
      random-detect cos 4 minimum-threshold percent 80 maximum-threshold percent 100
      queue-limit percent 20
      bandwidth remaining percent 15
      queue dropped pkts : 0

 

From the cisco white paper:

Configuration Examples For Monitoring QoS Statistics

The following example shows how to display the QoS statistics:

switch(config)# show policy-map interface ethernet 8/1

Global statistics status: enabled
Ethernet8/1
Service-policy (qos) input: pmap
policy statistics status: enabled
Class-map (qos): map (match-all)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: cos 0
police cir 10 mbps bc 200 ms
conformed 0 bytes, 0 bps action: transmit
violated 0 bytes, 0 bps action: drop
Class-map (qos): map1 (match-all)
0 packets, 0 bytes
CCIE RS 34827
0 REPLIES 0
This widget could not be displayed.