12-10-2012 04:41 AM - edited 03-01-2019 07:13 AM
Hi,
I have a pair of 1000v VSM running version 4.2(1)SV1(5.2)
The ESXi host is configured with 2 uplink connecting to 2 different switch.
Using port channel mac pinning.
i configured Network State tracking (NST) with default timer. and repin action.
but when i put "switchport trunk allowed vlan none" on the upstream switch facing the host,
the NST status said it is split.
but the VMs connected is not repin to other uplink.
is there any other misconfiguration that i miss? or my NST verification is wrong (though, the status is showing network is split)?
Thanks,
Ivan
07-18-2013 11:19 AM
Hello Ivan! It seems that we have the same problem. But here we have two channels, one with MAC and another with HM. Another people had configured the channel with MAC pinning and I can see that it is using another VLAN to track interfaces. Do you know how I can change tracking VLAN on NST?
07-20-2013 06:53 PM
Hi,
The below whitepaper has instructions on changing the VLAN for NST on page 6 for individual ESX hosts if needed.
01-24-2014 06:15 AM
By default Nexus 1000V chooses the lowest forwarding VLAN ID that is allowed on the uplink port-profile. You can choose and configure a low-id VLAN (say, 4) suitable for tracking. You have to remove all lower-id VLANs from the trunk:
port-profile type ethernet nexus1000v-uplink
switchport trunk allowed vlan 4-3967,4048-4093Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide