I am using 5548 and 5596.
both are running
5.1(3)N1(1a)
According to VPC domain documentation, you want to issue the peer-switch command to ensure that both switches in the VPC domain are STP root
these switches do not have the peer-switch command available.
(config-vpc-domain)# ?
auto-recovery VPC settings to enable auto recovery if peer is presumed non-operational
delay Initialization delay
dual-active Configuration when peer link is down but peer is alive
graceful Enable graceful features
ip Configure IP features
ipv6 Configure IPv6 features
no Negate a command or set its defaults
peer-config-check-bypass Ignore type checks on primary, when MCT is down
peer-gateway Enable L3 forwarding for packets destined to peer's gateway mac-address
peer-keepalive Keepalive/Hello with peer switch
role Role related configuration
system-mac Configure system mac address
system-priority Configure system priority
end Go to exec mode
exit Exit from command interpreter
pop Pop mode from stack or restore from name
push Push current mode to stack or save it under name
where Shows the cli context you are in
