Dear N7K expert,
We are using N7K switch in our lab for performance testing, I have a issue that I couldn't figure out why, hope someone can help.
Basically I found sometimes when I configure a port as trunked port, then add vlans to this port, but it seems that port still doesn't belongs to those vlan if I use "show vlan id xx". I'm using 5.1.5 software release, here's my config and command output:
Demo-7K# show run int eth 9/18
!Command: show running-config interface Ethernet9/18
!Time: Wed Oct 12 04:34:40 2011
version 5.1(5)
interface Ethernet9/18
switchport mode trunk
switchport trunk allowed vlan 163,203
spanning-tree bpdufilter enable
no shutdown
Demo-7K#
Demo-7K#
Demo-7K# show vlan id 163
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
163 VLAN0163 active Eth3/16, Eth3/32, Eth3/33
Eth3/34, Eth3/35, Eth9/16
Eth10/1, Eth10/21 ----------------------> interface 9/18 is not here
VLAN Type Vlan-mode
---- ----- ----------
163 enet CE
Remote SPAN VLAN
----------------
Disabled
Primary Secondary Type Ports
------- --------- --------------- -------------------------------------------
Demo-7K#
Thanks for help
Ning Chen