03-15-2022 05:08 AM
I have configured embedded NDB on a Nexus 93180YC-FX switch but when I try to add the same switch as a device in the NDB it is giving me error "Unknown Error", I am using the switch Management IP.
Also I am not sure if there is a license required to enable the Embedded NDB.
Solved! Go to Solution.
03-29-2022 12:59 AM
Hi thank you for your support. I have managed to make it work. I was missing the command
"nxapi http port 80", after configuring this command the broker connected successfully with the switch.
03-15-2022 05:28 AM
What do you use for NDB? NXAPI or OpenFlow? is the feature enabled?
What version of NDB and NXOS you run?
Cheers,
Sergiu
03-15-2022 05:55 AM - edited 03-16-2022 12:00 AM
Hi @Sergiu.Daniluk,
Using NXAPI, NDB version is 3.9-k9 and the NXOS version is 9.3.3. Please have a look at the attached error.
“NXAPI Device 10.242.100.18 reloaded, credentials are correct, rediscover the device when all the Ethernet modules are up ”
Do you think it is due to the required subscription?
03-16-2022 12:33 AM
Can you share "show module" and "show run" from the switch?
Sergiu
03-29-2022 12:59 AM
Hi thank you for your support. I have managed to make it work. I was missing the command
"nxapi http port 80", after configuring this command the broker connected successfully with the switch.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: