cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
714
Views
5
Helpful
2
Replies
Highlighted
Beginner

Nexus7009 replace chassis

Hi all,

I'm going to replace Nexus7009 with new chassis, I've backup configuration current Nexus to RMA Nexus.

only VDC management can restore backup configuration but for about other VDC how to restore.

I just dont want to copy and plate configuration in each VDC.

Please advice.

Pakorn S.

2 REPLIES 2
Highlighted

Are you just replacing the Chassis? Or are you replacing all Supervisor line cards too?

If you just replacing the chassis, and re-using the old supervisors you dont need to worry about you config.

If you are replacing your supervisors, then you need to configure you VDC from the system first. i.e. copy past the system VDC, confirm you VDCs are created. Then copy paste each VDCs config back.

Its pretty painless.

Here is a link for additional reading

http://www.cisco.com/en/US/docs/switches/datacenter/hw/nexus7000/installation/guide/n7k_replacing.html

hth

Highlighted
Cisco Employee

Hi Pakorn

Also please remember that for new chassis you also will need licenses.

You can transfer licenses from your old chassis to a new one using following link:

http://cisco.com/go/license

HTH,

Alex

This widget could not be displayed.