OTV Vlan mapping with F3 on 6.2(12)

[dnelson]

I have OTV working perfectly using Nexus 7700 and OTV VDC.  All blades are F3.  However, when trying to do Vlan mapping over OTV (i.e. local vlan is 500 and remote vlan is 700), I cannot get any traffic through the tunnel.

The research I've done says vlan mapping is supported on 6.2(6) and newer.  I'm beginning to think It is not supported on F3 blades.

Can anyone confirm or deny whether VLAN mapping in OTV is supported on F3 Blades running 6.2(12).

Thanks,

Dave

[Nuno Marques]

Hi Dave,

same problem here..

according to Cisco documentation  F3 cards started supporting depolarization on OTV on 6.2(8), but nothing related to OTV mapping:

OTV Support

Cisco NX-OS Release 6.2(6) provides support for Overlay Transport Virtualization (OTV) on the F3 Series modules. This feature is supported only in VDCs without OTV extended switched virtual interfaces (SVIs). VLAN translation and traffic depolarization are not supported.

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/6_x/nx-os/release/notes/62_nx-os_release_note.html#pgfId-813144

• F3 Series modules do not support the VLAN translation and traffic depolarization features in Cisco NX-OS Release 6.2(6).
• F3 Series modules support the OTV traffic depolarization feature in Cisco NX-OS Release 6.2(8).
•  

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/OTV/quick_start_guide/b-Cisco-Nexus-7000-Series-OTV-QSG.html

regards,

Nuno

[rocdrigo13]

Hello guys, I have the same problem, did you find any solution?

I have Nexus 7706 and F3 modules and running NXOS 7.3(0)DX1, but I haven´t been able to find any documentation that states if if supported in the new releases.

regards

Rodrigo