Hi All we have two N56128 and DELL BladeSwitche MXL 10/40
I tried to connect the MXL Switch to the Nexus by VPC (2 x 40GBit) via Cisco QSFP-H40G-CU5M cable.
N5K----N5K \ / \ / \ / \ / MXL
Unfortunately I don't get any active links. The interfaces on both sides remain in status down. Is there a special setting on the Nexus to use the QSFP-H40G-CU5M?
The cables on both switches are detected
Ethernet1/49 transceiver is present type is QSFP-H40G-CU5M name is CISCO-JPC part number is P3007U305000-1 revision is A0 serial number is JPC22170ETT-B nominal bitrate is 10300 MBit/sec Link length supported for copper is 5 m cisco id is -- cisco extended id number is 16
LEJ-RZE-SW-BC1-A2#sh int fo 0/37 transceiver Interface Name : fortyGigE 0/37
Cisco launched their solution for hybrid cloud solution for the Microsoft Azure public cloud back in September of 2017. Since that time, Cisco has enjoyed great success with installations around the world from Poland to Australia and many points in ...
NoticeThis is not an official guide, just something I've been testing to help during those "difficult" situations. All works here are my own!GoalsThere are some situations where we need to load an image onto a Nexus switch (or other network devices ...
I was playing a little with some show commands on ACI and i found that on leaves there are VXLAN tunnels also towards the APIC (10.0.0.1 in the figure); i was wondering why there should be these tunnels? APIC is using VLAN 3967 as infrastructure VLAN, and...