Send Sflow more than one agent ip -collector

[admin@atrinnet.net]

Hi Dear How send Sflow to more than Ip address

In switch Config only define one sflow ip-collector

How send two or more Collector my sflow Data  ????

[balaji.bandi]

have you tried like below : (not tried checking is this accepting ?

sflow collector-ip 10.10.10.1 vrf xxxx
sflow collector-ip 10.10.10.2 vrf xxxx

[admin@atrinnet.net]

I used this

sflow collector-ip 10.10.10.1 vrf default 

sflow collector-ip 10.10.10.2 vrf default 
But switch Can get one destnation For Collector ip 
Donnot send to two dst sflow data

[balaji.bandi]

i look at the document -

- The switch supports only one sFlow collector.

(May that destination one can send to other one) - just an iade

Device send to colelctor 1  - Collector can send to other collector - not good one but possible.

Like Agrigator - and Aggrigator send to different collector kind of ?

[Sergiu.Daniluk · Accepted solution]

Hi admin@atrinnet.net 

According to configuration guide, only one collector is supported:

---

The switch supports only one sFlow collector.

---

Reference:  https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus3000/sw/system_mgmt/7_x/b_Cisco_Nexus_3000_Series_NX-OS_System_Management_Configuration_Guide_7x/b_Cisco_Nexus_3000_Series_NX-OS_System_Management_Configuration_Guide_7x_chapter_010110.ht...

This apply for both N3K and N9K switches.

Best regards,

Sergiu

[admin@atrinnet.net]

Thank you For attention

You think i have this Config

feature sflow sflow sampling-rate 5000 sflow max-sampled-size 200 sflow counter-poll-interval 100 sflow max-datagram-size 2000 sflow collector-ip 192.0.2.5 vrf management (PRTG For see Flow Detail )
sflow collector-ip 192.0.2.6 vrf management (Fastnetmon For Detect DDOS)

sflow collector-port 7000 sflow agent-ip 192.0.2.3

But in switch i set one Collector -ip (Do not set 2 Destanation For Send Sflow Data)
How solve this ??? Send sflow Data two Destanation PRTG and Fastnetmon ?????