cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1397
Views
0
Helpful
0
Replies

VDC Stuck in "Create Pending" state

Brian Sudol
Level 1
Level 1

I am running into a problem were one of my VDCs (vdc 2) will not load on either of the dual sups I have in my chassis.  It looks to be stuck in a "Create Pending" state.  The only log that shows up that may be relevant is:

7K01 %$ VDC-1 %$ %CMPPROXY-2-LOG_CMP_IS_NOT_UP: Connectivity Management processor (on module 5) did not come up.

I'm guessing there is something wrong with the CMP? 

 

#show hardware

...

CMP (Module 5) no response

CMP (Module 6) ok

I've tried re-seating each supervisor, failing over supervisors with no luck. I've also tried to boot the 7K with either / or SUP installed with the same results. Has anyone run into this issue and / or knows what the problem may be?

Thanks.

0 Replies 0

Review Cisco Networking for a $25 gift card