06-17-2003 07:11 AM - edited 03-02-2019 08:12 AM
I need to use a 2610 to route vlans. Can you tell me if the NM-16ESW-1GIG will allow me to configure the sub-interfaces I need on the GB port to create my vlans, or is that module just a basic layer 2 switch and has 1 Ip configured for the switch? There would be a 1000BTX-GBIC in my 3508, whcih would be the uplink/dot.1q trunk. Thanks for your help.
06-17-2003 07:28 AM
It should. watch your ios dependencies!
07-20-2003 11:26 PM
You can use. Configure the GIG port as trunk and use dot1q/ISL encap for the same. Use sub-interface for each VLAN to be connected onto this trunk.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide