05-21-2004 01:09 AM - edited 03-02-2019 03:51 PM
I have a 2950 and the fa0/10 port keep bouncing I forced it 100 full on both ends log keep no messages and I did change the cable out.
05-27-2004 05:58 AM
This would be mainly due to problem of negotiation of speed and duplex settings on both sides. Do either auto-auto or configure same setting either side. Please refer the link for more information...
http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080094781.shtml#cfg_ts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community