**************
**3900 Stack**(VTP Domain: Cisco A / VTP Mode:Client)
**************
|
| (Fiber Uplink)
|
**************
**3900 Stack**(VTP Domain: Cisco A / VTP Mode:Server)
**************
|
| (Fiber Uplink)
|
**************
**3900 Stack**(VTP Domain: Cisco A / VTP Mode:Client)
**************
| |
|(Token Ring) | (Token Ring)
| |
******** ********************************
* 2612 * * IBM 5494 Remote Control Unit *
******** ********************************
| | |
|(T1 Line) |(Twinax) | (Twinax)
| | |
| *************** **************
| *Dumb Terminal* * Printer *
| *************** **************
*******
* 2612*
*******
|
| (Token)
|
********
*AS/400*
********
The problem is the IBM 5494 Remote Control Unit can no longer connect to the AS/400 at our remote site.
This problem started after changing the connect on our (3) 3900 series token switch stacks.
The old config on the switch stacks was:
**************
**3900 Stack**(VTP Domain: Cisco A / VTP Mode:Client)
***************
|
| (Fiber Uplink)
|
**************
**3900 Stack**(VTP Domain: No domain defined / VTP Mode: Transparent)
***************
|
| (Fiber Uplink)
|
**************
**3900 Stack**(VTP Domain: Cisco A / VTP Mode:Client)
***************
The router was not changed at all. The only change was made on that middle switch stack.
Do you guys have any ideas???? Please let me know..