cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
329
Views
0
Helpful
2
Replies

6500 - #set port broadcast 0.00%?

darkjedi
Level 1
Level 1

have any of you seen this in your configs without explicitly entering it. is there any other commands that makes the software automatically envoke this command. i saw this while running 5.2(3).

2 Replies 2

cbassett
Level 1
Level 1

Maybe by setting it to 0.00% by default effectively disables broadcast supression?.

If it was enabled and working but set at 0.00% the port would not pass any broadcast traffic whatsoever.

I understand what the commands does, but I am trying to figure out if there are other command line interface commands or configuration commands that makes the IOS automatically enter this command into the config.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: