cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
262
Views
0
Helpful
1
Replies

6509 etherchannel vlan cost

johnkauro
Level 1
Level 1

hi all,

i have 2 6509 connected with an etherchannel. the link is a trunk and there are 12 vlans configured. i want to change the port cost for all vlans.

i have found the following commands:

"set spantree channelcost","set spantree channelvlancost","set channel cost".

is there any difference between them?

also, can i use the command "set spantree portvlancost"?

Thanks.

1 Reply 1

c.lemaire
Level 1
Level 1

Hello,

As far as I know, the commands "set spantree channelcost" and "set spantree channelvlancost" are used to compute and set automatically the portcost and the portvlancost for each channel members. These commands are more a sort of macro than real commands. They will never appear in the config.

Before using the "set spantree channelvlancost" command, you need to configure the preferred vlans with the command "set spantree portvlancost [preferred_vlans]"

I dont know the command "set channel cost".

And yes, you can use the commands "set spantree portcost" and "set spantree portvlancost" but then you'll need to compute the aggregated cost manually.

I hope it helps.

Regards,

Christophe

Review Cisco Networking for a $25 gift card