12-10-2004 02:03 AM - edited 03-02-2019 08:30 PM
Hello,
I have a Cisco 7613 with two modules MSFC2 running 12.2(17d)SXb1. The two modules are for redundancy.
I have note that:
- Module 1 active + module 2 standby: If I take off from the rack the active module, the module 2 does not become active and sometimes crashs... It 's just stays in standby mode !
- Module 1 active + module 2 standby: If I make a soft switch over via CLI: redundancy force-failover, same behaviour: the module 2 does not become active and sometimes crashs... It 's just stays in standby mode !
Any help .? Thx in advance.
12-10-2004 06:32 AM
Can you see if there is a crashinfo in the Supervisor in slot 2? If slot 1 is active, you can do a "dir slavebootflash:" and "dir slavesup-bootflash:". If you have a crashinfo, attach it along with an output of sh ver, sh mod.
12-10-2004 09:12 AM
12-10-2004 09:52 AM
The standby is failing due to inbandping failure.
*Dec 7 16:19:31.381: %PFREDUN-SP-STDBY-7-KPA_WARN: RF KPA messages have not been heard for 27 seconds
*Dec 7 16:19:58.381: %PFREDUN-SP-STDBY-7-KPA_WARN: RF KPA messages have not been heard for 54 seconds
*Dec 7 16:20:25.382: %PFREDUN-SP-STDBY-7-KPA_WARN: RF KPA messages have not been heard for 81 seconds
*Dec 7 16:20:52.382: %PFREDUN-SP-STDBY-7-KPA_WARN: RF KPA messages have not been heard for 108 seconds
*Dec 7 16:21:19.382: %PFREDUN-SP-STDBY-7-KPA_WARN: RF KPA messages have not been heard for 135 seconds
*Dec 7 16:21:46.382: %PFREDUN-SP-STDBY-7-KPA_WARN: RF KPA messages have not been heard for 162 seconds
*Dec 7 16:21:54.650: %CONST_DIAG-SP-STDBY-3-HM_TEST_FAIL: Module 2 TestSPRPInbandPing consecutive failure count:5
I did some research and found couple bugs which were internally found during testing and this issue was not seen in later releases. If the standby Supervisor stays long enough, upgrade your IOS to 12.2(17d)SXB5. If it does not, pull out one Supervisor and upgrade one supervisor at a time and see if it stabilizes. Release notes are at
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/ol_4164.htm
12-10-2004 10:19 AM
Hello,
Thanks for your answer.
Could you please tell me which bugs match the traces I have post .. the id of the bug or some explanation of the bug .. hence I can request the upgrade.
Thanks in advance
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide