i got my hands on an old AP.While it boots, the CLI shows an error.
The system is unable to boot automatically because there are no bootable files to boot.
It was a lightweight OS, i made a mistake.
delete /recursive /force flash:c1240-.....
and now i have a Problem, i got "c1240-k9w7-tar.124-25d.JA.tar"
but i dont no how to install it or how i get it on the AP
it just shows over a very long time
Retry 0: Got fd for sector ACK
I use minicom und tried xmodem, but i dont know how to install it.
Go to Solution.
hope this helps
View solution in original post
post is already marked as solved but if you encounter problems when executing the above procedure you can try this- configure tftp server- acquire image and rename to .default- use mode button and power ondetail described in Erasing Flash and Reloading the Access Point image on Cisco AP - Cisco Community
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: