I need some help, iam going to have ADSL and want to create a BVI interface with my vlan bridged, i am trying to get the wirless to work in DHCP and it connects but i can not get a IP address can someone please either explain how to do it or put a basic config up for me.. i am wrecking my brian trying to figure this out..
I have tried multipule times with no success i get hte ADSL working but my wireless just does not want to let me connect!!!!!
Here is my config for my Wireless,as per what i have been reading and know of wireless(Not Cisco) i have left this
wide open for anyone to conntec but yet... Still can not connect to it or get a DHCP address, what am i doing wrng here?
Right now i am not even trying to Bridge(Did a Reset on it)just want to prove out my Wrieless before i
start anything else.
*Oct 26 02:09:51.035: %LINK-3-UPDOWN: Interface Dot11Radio0, changed state to up
*Oct 26 02:09:51.035: %LINK-3-UPDOWN: Interface Virtual-Dot11Radio0, changed state to down
*Oct 26 02:09:52.035: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to up
*Oct 26 02:09:52.483: %SYS-5-CONFIG_I: Configured from console by cisco on console^Z
*Oct 26 02:10:21.755: %DOT11-6-FREQ_USED: Interface Dot11Radio0, frequency 2462 selected
ip dhcp pool X
network 10.10.10.0 255.255.255.248
lease 0 2
no ip address
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0