I am having a little situation here; for some reason I can get my switches and routers to display the dhcp relay even though it shows to be configured on the network's vlan. For example, when I entered the following command; SW# sh ip dhcp relay info...
Forum Posts
Hi,I would like to understand the meaning of the number appended to the filename at the output of a show bootvar. ,1 or ,12. I could not find a definitve statement at the cco. Can anybody help ?Switch>sh bootvarBOOT variable = bootflash:cat4000-is-m...
Resolved! L3 Switch with IP Routing
Hi everyone,Regarding activating IP Routing on a l3 Switch I am a bit puzzled about how that would work.Let's say we have a 24 ports switch on which we have sdm prefer and IP Routing commands applied.If we no switchport port 0-11, while keeping ports...
Hello everyone,I am encountering an issue with my ASA 5515X running ASA Version 9.1(2) where traffic from devices in VLAN 99 cannot communicate with an external network (specifically 10.0.0.0/8).Here is an overview of my network configuration:ASA Con...
Resolved! L2 connection over L3, L2TP or VXLAN?
Hi,I just thought that between VXLAN and L2TP are same to send Layer 2 transport over L3. What is the major different for these both solution beside the function (L2TP are VPN terms and VXLAN are switching terms)?Glad to hear your response!
I just reset a SG350X and its console is showing odd characters while set to 115200 - 8/1.According to the switch documentation, it should use 115200 speed by default.I've tested all other speeds and none of them print the correct characters. However...
I can't bring up a MPLS TE tunnel with fast-reroute Node Protection, here is the error I get. *Feb 18 11:21:31.137: %MPLS_TE-5-LSP: LSP 2.2.2.2 5_192: DOWN: path error I attach the headend's config interface Tunnel5 ip unnumbered Loopback0 tunnel...
Good Morning, my organization is switching an existing circuit to a new MPLS circuit. I've been searching the Internet for best practice for how long to keep old circuit active before decommissioning it while building confidence on the new MPLS circ...
Resolved! Subnetting
The acquired building consists of a reception department and an administration + management department. After consulting with the team, designed the following layout. After some minor adjustments, our our technical department to install the hardware ...
Spoiler We have an odd situation on our network. We have several hosts that are on the far end of radio links that we cannot reach unless we clear the arp on our core switch and then initiate a continuous ping to. If the ping stops we cannot reach...
Hello everyone I have a statement below:You need to design an corporate The copra consist ofComputerPrinterAccess pointAny requiredName your equipment required in your network as per the vender specificationsType of data traffic must include , ftp, v...
Does anyone know if there are ISR1000 series routers that can be used as Act/Act with Dual SIM for 5G/LTE? Thanks
I have the Cisco ISR 4461 and I want to configure SSL-VPN on it, I did a system upgrade to Cupertino, Version 17.07.01a, RELEASE SOFTWARE (fc1). I have read many documents about it supporting this feature but unfortunately, after the upgrade only th...
hey there - so recently we noticed that almost all cisco catalyst devices have stopped sending logs to our central log servers (more than 1). Upon investigation and google - turns out most of the syslog servers were showing 'down' when doing a "show ...
Hello,I try to setup a dial-in server with 3825 router and NM-8AM-V2 card. but I am facing some issues. The purpose is to allow incoming connexions from various devices who still use analog modem connexion. These devices are directly connected to RJ1...
