Dear All,I would like to know more about Flow-Control on Ethernet copper and Gigainterface as we are planning to enable it, based on recommendation from one of our Netapps(storage device) consultant as they have enable it from their side and now the...
Hi All, My question is that I would like to know if I 'clear ip route' on an EIGRP environment which would clear the IP routing table,would the EIGRP neighbor relationship be lost ? This is because since the IP routing table is cleared, then c...
Hi Guys,I have implemented STP onto our l2 network - I now want to force a switch within the loop to use another path as apposed to the one selected by STP. I have configured the Port-priority with my prefered int having a higher priority but the swi...
Hi,Since short I receive the following message once and a while.Jun 29 09:03:27.459 CEDT: %SCP-4-DACK_TIMEOUT_MSG: SCP delivery ack timeout for opcode=11DJun 29 09:09:49.510 CEDT: %SCP-4-DACK_TIMEOUT_MSG: SCP delivery ack timeout for opcode=11DAccor...
Can anybody confirm if we really need to specify the speed under a Gigabit interface (ws-x6748-tx) if we want to activate the Storm-Control feature. Without the speed fixed we received sometime the following message :"need speed to config thisro_rtp_...
hii don't understand what is the meaning of Permanent Virtual Circuit, & Switched VC . and the differnce between them, if u can explain me, i will thanks u a lot
i would like to know how much bandwidth it's take to transfer on the lan the follow subject:snmp getsnmp setios versionios upgrateset configurationThe question is about 2811 routerthnks you.
I want to connect 18 GBIC in my Edge switch to one Catalyst 4506 in Distribution Layer. can I use 18 port Gigabit Ethernet Module, server switching (WS-X4418-GB) or I have to use 3x 6port Gigabit Ethernet Module (WS-X4306-GB).Thanks for your help.
Ok, I thought I had the reason for the VLAN interface command down. I thought it was either used for switch management or routing between VLANS? However, now I realized that some communication wont work with out this command which doesnt make sense...
I have several buildings with fiber transceivers between them, can I implement 802.1q trunks between my catalyst 3550s? Currently these are access ports. There are no gbics slots available to use the WS-G5484, thus I am using the transceivers.
Hi All,Does ip helper-address work with 2 ip ranges in a VLAN in a catalyst 3750?ip forward-protocol udp 6112 int vlan 1ip address 192.168.0.1 255.255.255.0int vlan 2ip helper-address 192.168.0.100ip address 192.168.1.100 255.255.255.0ip address 192....
3550 Gig0/1 port connected to 5500. The 3550 side does not show CDP information. The 5500 side does show CDP information. Do the 3550's support CDP over Gig links? Or is there some other problem why the 3550 doesn't see the CDP nei.?
Hi guys,I am having problem. I am not sure about this issue. Recently, I have new switch(2950) plugin into the Core switch. However, it keep generating log every 30 mins on my core switch. any idea about this problem?2005 Jul 01 22:51:15 GMT+2 +07:00...
