Other Network Architecture Subjects

Hi All,what would this be..?File "xmodem:" successfully copied to "flash:c2900XL-hs-mz-112.8.11-SA6.bin"switch: )$Unknown cmd: )$switch: CW_MEDIA$RAM$Unknown cmd: CW_MEDIA$RAM$switch: CW_SYSDESCR$Cisco Internetwork Operating System SoftwareUnknown cm...

Hi All,what are my options here..? Is this Switch gone..? RAM is an on-board chip, yes..? Cheers.Failed data line test.addr=0x80000, sent=0x00 recv=0xF600000Del Mar Failure (3rd Del Mar): Failed Notify RAM POSTC3500xl POST FAILURE: Failed Notify RAM ...

Have a few questions on cisco tunnel (be whatever mode GRE or Ipinip tunnel )How is the tunnel source nominated,does it always have to be associated with the routers physical interface ip address (primary secondary etc) or can any arbitrary ip addres...

Hi,Would like to know whether serial interface that resetted itself will cause ISDN to kicks in? The BRI interface is used to act as backup to my serial link.When I issued the command show interface serial, i noticed that the interface is resetted 31...

Hello:Have a Cisco 2900 and HP 4000 servicing my LAN...cross connected. There are times when I can take a patch from the Cisco and patch to the HP and the device is unreachable....put it back to the CISCO and I am fine....port settings are identical....

I just want to know that why there is only 802.IQ Trunking support in Cat2950.Why not ISL, Is it true that 802.IQ is better than ISL,Why Cisco left ISL in 2950.Pls explain.

Hi All,trying to set the IP add on a Catalyst 2900 in ronmon and get the following error,switch: IP_ADDRESS=192.168.0.1Can't set variable with illegal char "x1b) in name.What is wrong with this.?--coolboarederguy... Yeah, K, Who Stole The Soggy Biscu...

hi,i need to know how i can keep a track on my ISDN calls ...something sort of logs for the same .i mean i should be having a detail for for how much time the ISDN has worked ..also is there a way to stop ISDN calls after 3 bad attempts .Regards

We have one internet gateway links with a provider terminating in one router. This gateway router is part of OSPF IGP running in our network. We are injecting /originating default for the IGP in network & outbound traffic is flowing through the gatew...

Hi All,can the xmodem[1]: {read-only} be changed to write in ronmon..? I'm getting a permission denied when attempting to copy from tftp to a Catalyst 2900. How is it done...? Cheers.List of filesystems currently registered:flash[0]: (read-write)xmod...

I have a 2514 that has two ethernet ports and one serial. The serial link is on a T1 link and the two ethernet ports are plugged into a switch with 2 vlans....of course there are separate networks on them. OK, the problem is I cannot get my to lans...

Hi , quick questionWill 802.1Q trunking work between two FE ports running at only 10MBps Half-duplex ?(they are both connected via wireless kit)

Is it safe to say that a Vlan would be as good as having two physical seperate networks? The reason I ask is that we want to have the internet on the company Vlan and then a secure vlan for only internal data. I don't want to have any contact from ...

This is a soapbox posting rather than a problem, so I won't be surprised if nobody answers.In this forum, we see lots of problems that boil down to duplex mismatches on FastEthernet. Most of them are cases where full duplex has been fixed on one sid...