hiwant to know if the CAtOS software for cat4000 sup and switch2948G are same ? ON the download page for 2948G, there are all images named for cat4000 series only.thanks
This is a test environment. Sun Server, 2950 switch, Terminal server all connected to 3 Test Chassis's. 4506 & 4006 chassis's with Sup I-IV. It's only the Sup IV I seem to have problems with. During the test script, the Ethernet I/F on the Sup IV fai...
Hello,one of our CAT6509/SUP2/MSFC2 shows a cpu load between 30 and 40% (normal load during the last 12 months < 5%). "sh proc cpu" does not identify a specific process with high cpu consumption.Any ideas what could cause such a behaviour ?Thanks, Wo...
Hello, My Name is chirag pandya,i have one 7513 router which has two RSP, can i configure it as load sharing between 2 RSP??Thanking You,Chirag Pandya,Sr. Network Engineer,GUJARAT ONLINE LTD.GANDHINGAR,GUJARAT,INDIAPh: +91-9825364046
General question. On a cat switch (6509, 3550, etc) with users connected to ports, if I clear the ARP cache via IOS command line, will the users loose connnectivity?
Hi All :I received an older (May 1999) Cat3500XLResetted it to factory defaults.During testing I figured out that it was not forwarding packages until the switch was ping'ed from one of the connected computers.After the ping switch works just fine......
Hello Guys , I have a 1721 router with a ethernet and a WIC 2T smart serial card.I am have to do DLSW and SDLC , but enfortunetly i am not been able to run both these commands on my router.Nor " encapsulation sdlc " in my serial interface .IOS versi...
Do you know if exits a document with a table of all 6509 high-availability compatible CatOS versions ?Actually, I need to know if version 7.6(9) is compatible with version 5.4(2) to use the high-availability feature in a Cat 6509 with supervisor engi...
I am trying to upload the embedded ciscoview to my catalyst 4006 (SUPII+). for some reason I keep getting the following information when I try to install the software.Cat001#archive tar /xtract tftp://x.x.x.x/Cat4000IOS.v9-0.tar bootflash:cvExtract ...
If the switch suppots the "igmp" function,the multicast traffic sends to the port that multicast receiver is connected. But,if the switch does NOT support "igmp" function,multicast traffic sends to the all ports.I think that it looks same as broadcas...
