Other Network Architecture Subjects

Hi Everyone,I am trying to enable VLAN Tagging between a 3750 and a FAS270 Filer. What I want to be able to do is pass multiple VLANs (1 and 3) between this filer and switch. I have completed all of the necessary configuration on the filer and have e...

hi, I want to know how to configure point to multipoint on cisco 1700 using Wic 2T

Currently my network works on static route and if any of the router fails it will work on EIGRP? you can assume my network as small network in triangle form can you please tell me if I have to divert from EIGRP to OSPF what all the changes I will nee...

HiI'm trying to setup VACL capture on a Sup720a running CatOS 8.3.5 with a 6148-10/100 blade:set vlan 100 set security acl ip cap_acl permit ip any any capture commit security acl cap_acl set security acl map cap_acl 100 set security acl capture-port...

With a 4507 at the core and 3550s on the edges.What technologies are available for dynamic vlanallocation to endpoints ?

Here is a crazy problem I have been struggling the whole day.Two routers (2620 and 2514) are connected to the same switch on the 10.1.0.0 network.All the desktop in the 10.1.0.0 network have the default gateway as 10.1.1.30 (2620 ehternet interface)....

1. In load balancing or load sharing, where does reassemby of the packet occur? The destination's serial network interfaces, or the destination host?2. If any fragment is missing, the entire sequence of fragments will need to be retransmitted. Is thi...

I'm looking to put together a cheap but high capacity LNS for DSL (PPPoE over L2TP) customers. Looking at a 7200VXR with a NPE-G1 or a 7304 with a NPE-G100. Both are the same processor and I can put 4 OC3-ATM interfaces in each.Seems reasonable eno...

Hi, I Have a Router 3800 Series with the IOS 11.x and have a Frame Relay circuit of 128 Kbps, we need change the bandwitch to 512 Kbps, What I be modify in my router to work with these new configuration what are the steps?Thanks Fabian

Is there any document mention that the branch office using an E1 link can connect to a Multichannel T3 in the Data Center 7206.As I can see from the document, T3 support up to 28 T1. But didnot mention about E1.Is it possible?Thanks for help ...

Hello All,I'm just beginning to learn Cisco technologies. I have a 2514 router w/2 Ethernet (AUI) ports. I also have a 2Wire DSL modem. I would like to place the 2514 directly behind the DSL modem and use 1 of the 2 LAN's (From AUI-0)for a Web ser...

I am attempting to upgrade the flash memory in a 3640 router so that I can upgrade the OS. I removed a 16MB flash card from a 3620 router, installed it in the 3640 (Bank1) - Bank0 contained a 4MB card with the original 3640 OS, and erased the 3620 O...

I have purchased new Cisco Cat2950 Switch. But i just want to know that when i make it up its LEDs on each port and activity ports are not displaying lights brightly.I mean dim LEDs, however switch is working fine each computer is able to connect. IO...

I have two 3745 routers about 3/4 miles apaart connected via VERY high speed wireless. In the back of each router I have two GBIC's. Into each GBIC I plugged to gigabit capable millimeter wave microwave radios. I have these two GBIC's interfaces (...