Other Network Architecture Subjects

I've recently upgraded the SDM of a remote site C837 router to 2.0. Previously, it has had several occasions of hanging which required manual restarting.Now, I'm experiencing difficulty accessing the SDM. It returns error messages at different stages...

Hi all,Looking for help in configuring cisco 1721-adsl(wic).I want to configure the port ATM0 so that it connects to standard ADSL telephone line. Would appreciate a list of commands for this, or any websites with info.ps pc's will onnect to this ro...

Hi AllHope you can help. I have a network problem conecting the switches together.Here it is. I am connecting two switches through a les 100 mb link. One switch is a L2 swich and the other is a L3 switch. I have trunked them together using 8021q via...

I am installing a 3560 EMI and I want to do L3 routing between a data vlan and voice vlan. I have always used a router with sub interfaces. I documentation on Cisco site does not do a good job of explaining. Simple instal 3560 EMI to a PIX 506 them t...

Hello All,I have a PIX to PIX ipsec tunnel set up between sites and I want to route via EIGRP. I created the tunnels on the LAN routers behind the PIXes and can ping both tunnel interfaces (tunnels also show up up). I also created a static route for ...

We have a 4006 that is used for Voice and Data, we have all the ports configured with the voice vlan and also another vlan, We would like to extend the ports by adding a 3560. I have configured all of the ports for 3560 with a voice vlan and another ...

How can I configure more than one multilink virtual intefaces on router and how can I bundle two physical interfaces on virtual-templete1 and two other interfaces on virtual-templete2?I have four private lines circuits on HUB going two different remo...

Ihave a 12406 with a redundand rp my customr would like to switch over to the redundant rp without losing the bgp and ospf sessions.Any help would be appreciated. thanks Dennis

Mrplease when configuring an UBR7100, which quantity to adjust the system ? What is the avantage and disanvantage activing of these parameters ?-frequency upstream adjust-dowstream channel ID-upstream frequency adjust-upstream power adjust-upstream...

I have a Cisco 3640 Router used to connect 100 remote sites to the host site.I like to setup a laptop to monitor the traffic between the router and the remote sites.The router has two Ethernet adapters and two serial adapters. The serial adapters are...

I have to modify stop and start accounting ticket before writing then into a file, someone know how I can do that.Installed version is 3.07thanks,

I have Class C networks 192.168.1.0 - 192.168.40.0192.168.40.0 is a remote location connected via T1 to another T1 router and then connects my network via VLAN 555. On the 6509 MSFC interface VLAN 555. I want add access group in where only 192.168.1...

I'm currently writing a program that extracts cdp information from devices. However, the cdpCacheLastChange does not provide any information. Actually, all the cdpCacheEntry items above cdpCacheDuplex seem to only exist in the mib, but the devices ...

I want to create a vlan and add all my servers to that vlan to create its own network. I then want to add our new IDS system to sit in front of that server farm so it will alert us on the inside of whats going on...This server farm will incorporate a...

I get 1% packet loss and latency between 200-1000ms when pinging from the switch(cisco 2970) to any directly connected interface to a router (mainly 7206VXR) My concern is i have never seen packet loss or latency in a core network before!! i know tha...