Other Network Architecture Subjects

anyone?I have a frame-relay network setup throughout my city for all my locations. all sites come back to the main site through one host circuit. in addition to all my frame circuits, I have a dsl connecting to the frame network. all of these sites a...

Dear All,There is two link connected between R1 and R2. Both Router is running EIGRP. When use show ip route, I can see there is two path to the remote site. However, is there any command to check per destination load sharing is working?Thanks and Re...

Client RouterA (AS100) <--> ISP RouterB (AS200)Lan-10.0.0.0/24If ROuterB want to control what routes that it will advertise when receive routerA routes.is it possible to use prefix-list or distribute-list? how to do it? any difference ?I have tried t...

I have two dialers configured in my router as fallback to leased line and one dialer tries to dial to nearest location and in any case the first dialer is not able to establish connection then second dialer will establish connection to other location...

I have a rather interesting setup that I need to find a solution for. Basically I have chosen to use CBWFQ for QoS. I have two routers, let's say E0 are the transport interfaces between the two for now. Although these interfaces are Ethernet they ...

Hi , I need to know whether creating an etherchannel between two core switches running hsrp is a must ? Also what shud I configure the etherchannel as ?? shud it be a trunk , switchport or an routed interface ??? can somebody post me some sample conf...

Hi!!When we are doing vlans, the tagging process is transparent for the final users. I mean, the tag is only present between the backbone. Then, the tag is removed before the user gets the frame. Is this correct?? Is it possible for the final user to...

Hi Sir,I'm confused about the cost of default routes injected into an OSPF normal area by way of the "default-information originate" command configured on the ASBR.Attached is network diagram, configuration, problem description, and my analysis of th...

I believe there may be an incompatibility between the Cisco and the 3Com that’s causing these issues.When I ping from the 1711 I get the following whether or not we are in half duplex or full duplex or speed 10 or 100 mbps. Notice every third packet ...

Hianybody confirm the following scenario ?ethernet<-xDSL modem->ppp ----leased line ---- ppp<-XDSL modem->v.35<-router->ethernet- The serial interface in router and the ethernet on router are member of same bridge group- Bridge between two end points...

Hello,I've been trying to upgrade our AS5300 from 64mb ram / 8mb flash to 128mb ram / 16mb flash. With a little searching on the web I found the you have to change jumper J3 to get it to work with 128mb ram, that is now working.My remaining problem i...

I was wondering if anyone knew if it was possible to modify existing role permissions or to create user-defined roles within CiscoWorks 2000. None of the roles that exist by default are able to meet the requirements that we need, Hence we would like ...