Other Network Architecture Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 

Forum Posts

I am enable SAA on my routers to monitor jitter. The problem i am facing now is that, my jitter value is way too high from normal value. But only some of them given the normal value. Is there any special configuration i have to do into my probe or re...

I try to perform a Rip v2 lab, it seems success that 2620 can learn some network of from 1720 fast ethernet0, but I don't know why only 10.0.0.0/24 can't be learned.do you know what's the problem ?Pc(192.168.0.1) -> 1720 -> 2620 -> Nat router(192.168...

acbennyma by Level 1
  • 287 Views
  • 1 replies
  • 0 Helpful votes

We are trying to connect two 2950 distribution layer switches to two access layer 3Com switches. Both the 2950's are using 802.1Q for trunking. The 3Coms are connected to switchport access ports (not Trunks) in VLAN 10 on the 2950's. The 3Coms are no...

mwindley by Level 1
  • 271 Views
  • 2 replies
  • 0 Helpful votes

SEE,I WANT TO CONFIGURE RATE-LIMITING ON CISCO BASIC LAYER TWO SWITCH(2950).IS IT POSSIBLE WITH SOME HIGER VERSION OF IOS,IF THEN WHICH VERSION ON 2950 SWITCH. IF IT IS NOT POSSIBLE,CAN YOU PEOPLE SUGGEST ME SOME ALTERNATE.ARUN KACHROO

a.kachroo by Level 1
  • 167 Views
  • 1 replies
  • 0 Helpful votes

I have read Cisco's document on NAT-on-a-stick but neither of the examples directly apply to my situation and I can't seem to figure out how to get this to work. This is the scenario: We have an internal server at one of our locations that must hav...

thanekamp by Level 1
  • 439 Views
  • 7 replies
  • 0 Helpful votes