I am trying to monitor the statuses of EIGRP on my devices. I basically want to see when EIGRP is up or down. I am using Solarwinds as a monitoring tool and someone mentioned that the OID stated in the title would be useful. When applying this OID...
Make sure to register for the DNAC Installation/Deployment workshop happening tomorrow – Tuesday, June 26 at 1 p.m. EST / 10 a.m. PST. If you can't make it to tomorrow’s workshop, then no worries - this workshop happens every Tuesday! So make sure t...
Hello,
I want to redirect the requests via ip Multicast from one server directly connected to an Cisco 6500 to our servers that are directly connected to Nexus 5K.
When I try to insert the follow command:
(config)# mac address-table static 0100....
I wanted to post this so it might be useful to someone else who is facing this issue.
Customer has a Juniper, not sure the model, working fine with a Cisco ASA5515. Project is to replace the Juniper with an ISR 4451. When replaced the ISR would not ...
Hello All,
this is a very generic proxy question.
As i understand, proxy in ones browser will facilitate all connections to internet (http or https).
Please correct if this is wrong.
what is the exception to this rule , if using an application in...
Hi,
I have given a task of designing a network from scratch for approx. 5000 users, about 70% of which will be using VOIP on their laptops.
I do have a general idea but not sure which devices will best meet my requirements. I think 6500 series sw...
ip route 10.213.56.0 255.255.240.0 10.175.0.245 name VPN_NAT_Subnet
Attempting to static route the above network and the L3 switch is returning a inconsistent address and mask error...
Hi,
I'm struggling with using curl to send XML commands to the ICS API on a C220 Cisco Server.
For instance when I perform that command
curl -d "<aaaLogin inName='admin' inPassword='password'></aaaLogin>" https://192.0.20.72/nuova
using my real lo...
I want to create a route-map so that all IP traffic goes to the default route except a single IP address (192.168.40.1) which need to be set to next hop 192.168.5.254. I want to apply this to a VLAN.
The switch I want to achieve this on is a Cisco ...
Hi, I have been given an exercise to create a BOM for a 140 remote site network on a fiber backbone, Just need the appropriate switch and router models.
Hello, Can you tell me the difference between these two ACL statements? Usually the port is after the destination address but I've seen examples of DNS ACLs with the port in between the source and destination. Are DNS ACLs the only ACLs that can be s...
Hello, our client is looking to deploy several dozen Cisco IE-2000-8TC-G-B industrial switches in field cabinets throughout the province. The cabinets all currently have existing industrial switches from a different manufacturer (not Cisco), so our c...
Hi,
We at our company has to implement the CDP protocol on our devices connected to the switch. I have searched for the CDP protocol definition and the format of the TLVs but I have not found any. Where can I find the definition of this protocol?
