Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can you look over my new config to make sure it looks ok? This access server is an AS5400 with 8 T1 isdn pri lines attached. It’s only purpose is to be used a dial-in box to our network. It will not be used to dial out. It has 1 d channel for eac...
hi,i have a DHCP server x.x.x.x running in my LAN i want my remote office lan to get IP addresses from my DHCP server.I have applied IP helper address x.x.x.x on the lan of my remote office and on the serial of this office.Still i remote office users...
Hi Guys,We have a customer that has a bunch of 6506 chassis's. They needed dense gigabit presentation so we ordered 6148-GE-TX blades for the switches. We checked the software advisor to make sure Sup-1A-2ge (msfc1/pfc1) could run the correct softwar...
sir i have a 1750 with below configuration and facing a problem like it stops the internet access for the 15 users on the lan which are connected through the nat on the router after reloading the router it again works for a while but stops the surfin...
Dear allI work as an Customer service in ISPI have some client report that they did not take the correct BandWidth in the ADSL connection (SLow browsing and download)they take 512 Kbit Rate and the Download is 5 K byteI trablshoot with them and evry...
HiI have a problem with RAS on my router.When there is an unsuccessful callback from the router, the router is not able to answer the client's call on the same line again for a long time (approx.6 hours).Has anybody a good idea to solve this problem?...
hi, my switching background is a bit shakey. i have 2 simple questions for you guys:1) i have a cat2950 that is configured as the root of STP. it is also the VTP server. i want to make some changes so that our 4500 is the VTP server and ST root. this...
Hi,I have client that is connected to my router with BRI. We use "ppp multilink", so both B channels can be used. My client is the caller site and my router is the called one. My client says that all calls are ended in 120seconds although there is st...
I have a catalyst 2924C-XL and a HP procurve 2626, problem is I cant get them to trunk properly together, I have Cdp running and both see each other via this but am unable to ping or anything past this. PLEASE HELP!!, are there any underlying probs w...
i install ciscowork 2000 and ani server but when i would like to get the devices , it don't show any devices. I think the problem involve with this menu?server configuration > setup > ani server admin > discovery settingsi don't understand the Discov...
I've 1760 router connected to first ISP and PIX connected to second ISP. If connection to first ISP is failed i want that users use connection through PIX. What should i use for implement that design?
