Other Network Architecture Subjects

Hi Cisco Community, Im doing a architecture and i have some question about cisco service and products . Some basic information :  Total of GB port that they are using : 383 Total of SFP port that they are using: 72 Total of an Ap : 1 ( avg users 300)...

Hi all,I have installed CW and HP NNM in W2k server recently, and I am experiencing a problem. If anyone has any suggestion or information, please help me on this to get through.I installed these CW's CWCS2.2/SP2CM3.3/IDU6.0DFM1.2/IDU1.2.6RME3.5/IDU6...

I believe I can use 'mac access-list extended' command to filter MAC addresses on a Catalyst 3550 although it was also mentioned that MAC access list numbers from 700 to 799 are not supported. Since it is not mentioned (or included) in the Catalyst 3...

My understanding is below.Regarding a "ip igmp snooping",if I enable it on the Switch,multicast traffic streams to the port that the mulicast receiver is connected. If disable it,multicast streams to the "all ports" like a broadcast. Is it right ?If ...

I have a 3550 EMI. I get the following output on a 'router eigrp 1' Unknown routing protocolI know the 3550 EMI is capable of running EIGRP but I can't seem to turn it on. Any ideas?

When using following command ...  show run | redirect http://1.1.1.1/test.php ... it returns immediately to the promt. However the log shows following entry: %SYS-3-URLWRITEFAIL: redirection url write failed 'Bad file number' No ip packets arrive on ...

Hi Guys,I Was configuring TACAS on NEXUS 7000, suddenly the administrator of my ACS changing it's IP ADdress to another IP.Anyway, I was unable to change the ip address, even cannot remove itAlready try to delete the aaa authentication groupAnd also ...

Hi All, I have been trying to run snmpwalk on Nexus 5k but it seems like object ipAddressTable (oid 1.3.6.1.2.1.4.34) is not available on this switch. However this object ipAddressTable is working on Nexus 7k. From the Nexus 5000 support list from th...

HI, I am attempting to add " ip route 10.16.17.0 255.255.252.0 10.16.5.1 to a 2651. 10.16.17.0 network is a dmz interface off of a pix 515. The router is saying that it is inconsistent address & mask. Currently, there would be a lot of work to cha...

Dear Team, Can confirm the attached system architecture for the small industrial lan network. (Cisco 3850 & Cisco 3750 switches)   Thanks & Regards, Dinesh Karangutkar

Ahoy,I've read Cisco documentation and forum posts from a number of sources, and there doesn't seem to be any mention of how someone can issue commands like they would in a CLI environment on a console-less switch like the CE500. It is something that...

I am trying to implement 802.1X Port-Based Authentication with Cisco 3550 series switches. I am also using Cisco ACS server for authentication.1. What shoudl be the auth protocol between switch and AA server ( RADIUS or TACACSS ?).2. How does the mac...

My customer would like to do layer 3 routing on 3550-12G switch. The documentation only shows on IP routing but not on IPX. Does the box support IPX? From my understanding from the product info it does not support IPX but needs a better confirmation....